Information & Education

What Should Gun Safe Humidity Be? (And How to Fix It)

Silent Dry Hypercube gun safe dehumidifier, anti-rust, for a 150L safe

Gun safe humidity should sit between 30 and 50 percent relative humidity. Above 50 percent, moisture starts to condense on steel and rust begins. Below 30 percent, wood stocks can dry out and crack. Most safes in Canada run higher than 50 percent for at least part of the year, so this is worth checking rather than assuming.

Why 30 to 50 percent

Rust is a reaction between steel, oxygen and water. The water comes from the air. Once relative humidity passes roughly 50 percent, a molecular film of water forms on metal surfaces even though nothing looks wet. Past 60 percent it happens fast. Under 30 percent there is no rust risk, but wood shrinks, finishes check and anything with leather on it goes stiff. So 30 to 50 is the window: dry enough to stop rust, damp enough to leave the stock alone.

How to measure it

A cheap digital hygrometer from the hardware store does the job. Put it in the safe, close the door and read it after two days. The reading right after you open the door is the room, not the safe.

The Silent Dry Hypercube dehumidifier has a hygrometer built into the face, so you get the reading every time you open the door without a separate gauge.

Why your safe reads higher than the room

  • It is in the basement. Basements in most of Canada run 60 to 70 percent from spring through fall.
  • It is fire-rated. The fireboard lining is gypsum, and gypsum holds moisture. New fireproof safes are often damper inside than the room they sit in for the first year.
  • Cold guns went in. A rifle brought in from a November hunt sweats as it warms up. Close the door on it and that water has nowhere to go.
  • The door stays shut. No airflow means whatever moisture is in there stays in there.

How to bring gun safe humidity down

Two options that actually work in a closed safe:

Electric rod. Warms the air a few degrees so it does not condense. Needs a hole drilled in the safe and an outlet within reach. Fine in a heated room, useless at the cottage.

Renewable desiccant. A block that absorbs water vapour until it is full, then gets dried out and reused. The Hypercube is this type: no cord, no hole, microwave it when the hygrometer says it is saturated. Small for a cabinet, Medium for a 20 to 30 gun safe, Large for a big safe or a wet basement. For a pistol case, the Invisible Stone is the same material in a pocket-sized block.

Throwaway silica packets are not enough for a safe. They are spent in days and you cannot tell when. Our gun safe dehumidifier guide compares the options and how to size one.

How often to check

Weekly for the first month after you set up a dehumidifier, so you learn how fast the safe loads it up. After that, monthly is plenty. Spring is the worst season for most Canadian basements, so check more often in April and May.

Common questions

Is 60 percent too high for a gun safe?

Yes. At 60 percent you will see spotting on blued steel within a few months.

Does temperature matter?

Swings matter more than the number. A steady 15 degrees is fine. A safe on an exterior wall of an unheated garage that goes from minus 20 to plus 25 will condense every time it warms.

Can a dehumidifier make the safe too dry?

A desiccant self-limits. It slows down as the air dries and will not pull a safe much under 30 percent. Rods do not remove water at all, so they cannot over-dry either.

Do I still need to oil my guns if the humidity is right?

A light film of oil or VCI on the steel is cheap insurance. The dehumidifier does most of the work; the oil covers the day you forget to recharge it. See the full guide on Silent Dry storage products.

Related Posts